E1: 13/17: Pareto Analysis Percent Calculations Are Not Updated To Reflect Changes Made To Failure Analysis And Resolution (FAR) Codes (Doc ID 1626074.1)

Last updated on DECEMBER 15, 2015

Applies to:

JD Edwards EnterpriseOne Capital Asset Management - Version 9.1 to 9.1 [Release 9.1]
Information in this document applies to any platform.

Symptoms

Pareto Analysis P177661

Due to changed conditions, when the association Failure code with a work order is changed, this value will not change in Pareto functionality.

The Pareto analysis updates when a new work order uses a failure analysis and resolution, but if the initial analysis and resolution is determined to be incorrect, the system permits the work order analysis and resolution to be revised using unique analysis and resolution codes.  The new codes are not included in the Pareto analysis percents.  Only when the code is used on a new work order, is the new code included in Pareto analysis.

EXPECTED BEHAVIOR
-----------------------
Expect pareto analysis to reflect modified failure, analysis and resolution records.

STEPS TO DUPLICATE
-----------------------
The issue can be reproduced at will with the following steps:
1.  Enter Equipment or service work order.  
2.  Enter a Failure-Analysis-Resolution record.  
3.  Confirm new record is reflected in Pareto analysis.  
4.  Use the modify record check box to alter the analysis and resolution for the failure.  
 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms