# E1: 32: Dynamic Configurator - Cannot Change Segment Answer Where There Is a Two-Way Realtionship Defined In P3292

(Doc ID 1960513.1)

Last updated on DECEMBER 15, 2015

## Applies to:

JD Edwards EnterpriseOne Configurator - Version 9.1 and later
Information in this document applies to any platform.

## Symptoms

Dynamic Configurator Cross Segment Editing Rules (P3292) Enhancement. Use Case is as follows:

Segment 10 has UDC with Values 1 & 2
Segment 20 has UDC with Values A & B

The relationship between the two is as follows:

If 10 = 1 then 20 has to be A
If 10 = 2 then 20 has to be B

The converse is also true:
If 20 = A then 10 has to be 1
If 20 = B then 10 has to be 2

Currently, with Dynamic, if CSERs are defined based on the above, once Seg 10 or Seg 20 has been selected, it is not possible to then change either segment to select a different value, e.g.

10=1
20=A

Try to change 10=2 to get 20=B or 20=B to get 10=2, but it is not possible to do this as the 2 and B have been dropped from the UDCs by the original rule.