E1: 31: Hours/Minutes/Seconds are Being Updated using the R31122Z1I Inbound Hours and Quantities Processor but the Seconds are getting Truncated (Dropped off) in the Table F31122 (Doc ID 2195976.1)

Last updated on OCTOBER 21, 2016

Applies to:

JD Edwards EnterpriseOne Shop Floor Control - Version 9.0 and later
Information in this document applies to any platform.

Symptoms

R31122Z1I is dropping Seconds

Both begin time PBTM and end time PETM are populated into the F31122Z1 hours and quantities table in hours/minutes/seconds, however when the R31122Z1I runs to populate the F31122 table the seconds are dropped off.

Requesting to not truncate the seconds when updating the F31122 using Interop or interactive application P311221


The issue can be reproduced at will with the following steps:
1. Populate the P31122Z1 inquiry with begin and end time in hours/minutes/seconds
2. Run R31122Z1I
3. The F31122 drops the seconds

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms