My Oracle Support Banner

E1: 31B: THE INSTRUCTION METHOD - `FROM MOVE' NOT FUNCTIONING PROPERLY (Doc ID 2541075.1)

Last updated on AUGUST 14, 2021

Applies to:

JD Edwards EnterpriseOne Blend Management - Version 9.2 and later
Information in this document applies to any platform.

Symptoms

The instruction method - From Move not functioning properly

The system is not saving the calculate move value even if we enter the instructed after quantity in first place. The From Move Instruction Method is
causing Problems with Tank Volume Calculations


STEPS
-----------------------
Base Operation: R2T
Instruction Method: FROM MOVE

The issue can be reproduced at will with the following steps:
1. Enter the instructed move quantity and Clicked on calculate move and then save the operation and re-check the values.
2. Clicking on Calculate Move system shows no move volume in it.

Base Operation: T2T
Instruction Method: FROM MOVE
1. kept the instructed move quantity blank and save the operation and then re-open the same operation and enter the instructed move quantity and try to do the calculate move.
2. Clicking on Calculate Move system shows no move volume in it.
3. No values calculated




Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.