My Oracle Support Banner

E1: 31B: P31b94 Blend Operations Is Not Clearing Error 527WIM for the Next Operation After the to Vessel Was Changed for the Upstream Operation and the Also the Same Vessel Was Replaced as the to in the Next Operation (Doc ID 2667829.1)

Last updated on MAY 07, 2020

Applies to:

JD Edwards EnterpriseOne Blend Management - Version 9.2 to 9.2 [Release 9.2]
Information in this document applies to any platform.

Symptoms

P31B94 Blend Operations is not clearing error 527WIM for the next operation after the to vessel was changed for the upstream operation and the also the same vessel was replaced as the to in the next operation.

The issue can be reproduced with the following steps:

1. Setup the following operations 

  1.  R2TV, from BOL to TANK AN-UT-6
  2.  T2T, from AN-UT-6 to AN-UT-3
  3.  T2T, from AN-UT-3 to AN-UT-4 and AN-UT-5

2. Revise the operations to replace AN-UT-6 with AN-UT-2 

  1.  R2TV, from BOL to TANK AN-UT-2
    Do a find in the main P31B94 screen. Notice the red error (expected) that appears on the second operation, after the first operation is changed. HARD ERROR 527WIM 'No before lot was found for the entered vessel'.
  2.  T2T, from AN-UT-2 to AN-UT-3
  3.  T2T, from AN-UT-3 to AN-UT-4 and AN-UT-5 (no change)
    Do a find in the main P31B94 screen. Notice the red error that appears on the second operation is not cleared.

Work around: 

In order to clear the error, you have to check the (enable) the Re-Schedule Operations on the second operation header and save. Notice the error is cleared.

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.