My Oracle Support Banner

E1:31: R31410 Work Order Processing / R31415 Work Order Print Creates Closed Component Lines in P3111 Work Order Parts List When Hard Committing Inventory to Secondary Location (Doc ID 2858146.1)

Last updated on MARCH 24, 2022

Applies to:

JD Edwards EnterpriseOne Shop Floor Control - Version 9.2 and later
Information in this document applies to any platform.

Symptoms

P3111 Work order parts list program displays components with both closed line status and committed status after running R31410 Work order processing/R31415 Work order print with commitment and printing enabled to hard commit components to the secondary location. Primary location does not have any inventory available.

The issue can be reproduced at will with the following steps:

1. P3009 - Commitment set to Soft, hard when printing.
2. P41202 - Item availability for the component item shows no availability in primary location and 100 available in secondary location
3. P48013 - Create a work order for 10 quantities
4. R31410 - Setup processing option to bypass R31415 work order print and run work order processing to soft commit components to primary location
5. P3111 - Review parts list and observe the components are committed to primary location
6. R31410 - Setup processing option with printing enabled to hard commit components to secondary location and run work order processing
7. P3111 - Review WO parts list and observe duplicate components lines with closed status corresponding to primary location are created along with the committed lines to secondary location.


Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.