E1: 90CB: Setting up Territory by Country, State, Zip (Doc ID 642154.1)

Last updated on FEBRUARY 17, 2016

Applies to:

JD Edwards EnterpriseOne Sales Force Automation - Version 8.12 and later
Information in this document applies to any platform.


When trying to setup a Territory (P90CA140) by country using the Assign Country button within the program it pulls up a Search and Select Countries screen which is the UDC table 00/CN. This view is only showing 16 of the countries. Review the UDC 00/CN directly and it shows 216 countries in the table.
Originally the table had 11 and 211, then when added 5 additional countries to the UDC table, was able to see the new ones through the Territory program. Tried removing a country from the UDC and then adding it back to see if this would show the Territory, but this did not work. Also look at this UDC table from the Address Book and can see all 216 rows. Is there a refresh program that needs to run for this to work?


Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms