E1: 33: R3382 Using Shifts and Efficiency at Shift Level in Capacity Planning (Doc ID 653810.1)

Last updated on NOVEMBER 17, 2016

Applies to:

JD Edwards EnterpriseOne Requirements Planning - Version XE and later
Information in this document applies to any platform.

Goal

Information Center: Overview of JD Edwards EnterpriseOne Requirements Planning > Information Center: Using JD Edwards EnterpriseOne Requirements Planning > Document 653810.1

In the situation where a workcenter has 3 shifts with different labor efficiency, capacity and hours defined, the blank shift in the F3007 Resource Units table has the correct calculation of hours, but the labor efficiency is defaulting from the workcenter data (F30006) rather than calculating an average value from the 3 shifts. Is it possible to have the blank shift calculated with an average labor efficiency value?

Solution

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms