How To Configure WebSphere Application Server 6.1 Integration With OAM 10g Without Reverse Proxy
Last updated on APRIL 03, 2018
Applies to:COREid Access - Version: 10.1.4.2 to 10.1.4.3.0 - Release: 10g to
Information in this document applies to any platform.
This configuration option would be applicable only for WAS environments where there will not be any reverse proxy webserver with WebGate serving WebSphere application requests.
The 'Configuring WebSphere Application Server Without Reverse Proxy' configuration option was introduced with the OAM 10.1.4.2.4 version of the OAM Connector for WebSphere Application Server. It is not supported with earlier releases of the OAM Connector for WAS.
'Configuring WebSphere Application Server Without Reverse Proxy' is documented in the Integrating with IBM WebSphere PDF document that is provided with OAM Connector for WebSphere software from release 10.1.4.2.4 and later.
This article does not replace the Integrating with IBM WebSphere PDF document, which is an essential information source for the OAM Connector for WebSphere.
It is assumed that the Integrating with IBM WebSphere PDF document has been read and understood, that the environment to be configured is supported and that the required software is already installed, apart from the OAM Connector itself.
The steps in this document were tested with WAS release 6.1. They have not been tested with earlier versions of WAS supported with the OAM Connector and some of the configuration details in this document may not be applicable to the earlier releases.
This article does not cover Best Practices: it provides a simple test setup for OAM-integrated access to WebSphere administration console using the Primary UID for development environments only.
Sign In with your My Oracle Support account
Don't have a My Oracle Support account? Click to get started
My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms