My Oracle Support Banner

How to Setup LDAP Sync After Install in OIM 11g (Doc ID 1272682.1)

Last updated on FEBRUARY 21, 2020

Applies to:

Identity Manager - Version 11.1.1.3.0 to 11.1.1.3.7 [Release 11g]
Information in this document applies to any platform.

Purpose

 

*** NEW ***
o  Take a look at the OIM Information Center, with resources for all your needs with this product.
o  If you have a question, or would like to discuss a topic, you may want to consider filing a thread in the Identity Management MOS Community, where customers can draw on and contribute to the expertise of the IdM Community.



The purpose of this article is to explain how to setup Oracle Identity Manager (OIM) 11g LDAP sync feature after the product install is done.
Currently, the product documentation only explains how to do this setup during the install.
See Setting Up LDAP Synchronization for pre-requisities. This same document will also be referred later in this article.

Note: This article is applicable to OIM version 11.1.1.3 only. Steps for 11.1.1.5 are not the same, and product manual has documented steps to setup LDAP sync after install.

Scope

This article is intended to everyone who need to enable LDAP Sync feature after the install of OIM 11g.

Details

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Purpose
Scope
Details

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.