My Oracle Support Banner

Using OCM (Oracle Configuration Manager) With SOA Suite 11g (BPEL, B2B, BAM), BPM 11g or BPEL PM 10g (Doc ID 1321742.1)

Last updated on SEPTEMBER 04, 2018

Applies to:

Oracle(R) BPEL Process Manager - Version 10.1.3.1 to 10.1.3.5.0
Oracle SOA Platform - Version 11.1.1.1.0 and later
Information in this document applies to any platform.

Purpose

The objective of this bulletin is to describe how to use Oracle Configuration Manager (OCM) effectively against Oracle SOA Suite 11g and BPEL Process Manager 10g.

Scope

The article is intended for SOA Administrators, Consultants and Support Engineers. It will show how to configure and run OCM against an Oracle Suite 11g or BPEL Process Manager 10g installation.

This support article will not provide a comprehensive guide to Oracle Configuration Manager (OCM). Such detail can be found in the following articles for Fusion Middleware which are relevant to a SOA installation as well:

Information about other diagnostic tools like Rremote Diagnostic Agent (RDA) is available in the following articles:

Details

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Purpose
Scope
Details
 Install OCM
 Configure OCM
 Configuring OCM in Connected Mode
 Configuring OCM in Disconnected Mode:
 Run OCM and Upload OCM collections to a Service Request or to the CCR in MOS
 Benefits of using OCM
References

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.