Network Interfaces Not Operational After Motherboard Replacement on Exalogic Nodes
(Doc ID 1569243.1)
Last updated on AUGUST 02, 2024
Applies to:
Oracle Exalogic Elastic Cloud Software - Version 2.0.0.0.0 and laterOracle Exalogic Elastic Cloud X2-2 Hardware - Version X2 to X6 [Release X2 to X6]
Linux x86-64
Oracle Solaris on x86-64 (64-bit)
Oracle Virtual Server x86-64
Symptoms
After system board replacement on Exalogic node, Network interfaces cannot be used. Network Interfaces responds from the local host, but fails to connect to other hosts.
Below is an example where eth0 interface cannot be used. ( Applies to eth1,eth2,eth3 - any onboard eth devices )
eth0 network interface shows status up, but does not function as expected.
Example:
(Original IP and netmask is masked by x.x.x.x and y.y.y.y in the output below)
Changes
This issue is noticed after system board replacement in Exalogic nodes.
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
| Symptoms |
| Changes |
| Cause |
| Solution |