My Oracle Support Banner

chain authentication does not work in 11gR2PS1 (Doc ID 1620833.1)

Last updated on MAY 24, 2022

Applies to:

Oracle Access Manager - Version 11.1.2.1.0 to 11.1.2.1.0 [Release 11g]
Information in this document applies to any platform.

Symptoms

Chain authentication does not work in 11gR2PS1 (applicable only to 11gR2PS1 rtm up to 11gR2PS1 BP02 included (so from 11.1.2.1.0 to 11.1.2.1.2 included).  

Following was the scenario tested:

1. Setup 2 ID store:

2. Copy the default LDAPScheme, and make it reference custom LDAPPlugin module

3. For the custom LDAPPlugin Module: 

initial=UI1
UI1 success=UA1, failure=UI2
UA1 success=success, failure=UI2
UI2 success=UA2, failure=failure
UA2 success=success, failure=failure

Where U1 reference IDStore1 and UI2 reference IDStore2

Test case: Supply a username that exists ONLY in UI2, OAM appeared to proceed with UA1 and errored out, instead of going into UI2

 

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.