After Configuring Connection Filter To Disable t3/t3s, Web Application Became Extremely Slow. (Doc ID 2424164.1)

Last updated on JUNE 08, 2023

Applies to:

Symptoms

T3/T3s connection was disabled with default connection filter by following the steps in <Document 1508748.1> Steps to Configure Weblogic Connection Filters. And the connection filter entries are as below:

127.0.0.1 * * allow t3 t3s
* * * deny t3 t3s

However, web application deployed on this server became significantly slower than before this connection filter configuration. And its performance will become normal again, if the filter is deleted.

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.