ODI 12c Scenario Loses "Used by" Information when Parameter "Synchronous / Asynchronous" is Set (Doc ID 2508182.1)

Last updated on OCTOBER 18, 2019

Applies to:

Symptoms

In Oracle Data Integrator (ODI) 12c, when adding a Scenario to a Package and the parameter "Synchronous / Asynchronous" is set to either "Synchronous Mode" or "Asynchronous Mode", the Scenario's "Used by" no longer shows the Package.

To reproduce:

1. Create a Scenario, version 001.
    
2. Create a Package, add Scenario version 001. Save.
   --> the "Used by" of the Scenario version 001 shows the Package, as expected.
    
3. In the Package, edit the Scenario step. In the "Properties" "Parameter" at the bottom of the screen, set "Synchronous / Asynchronous" to "Synchronous Mode". Save.
   --> Unexpectedly, the "Used by" of Scenario version 001 no longer lists the Package.
   
   
4. In the Package, edit the Scenario step. In the "Properties" "Parameter" at the bottom of the screen, set "Synchronous / Asynchronous" to "Asynchronous Mode". Save.
   --> Unexpectedly, the "Used by" of Scenario version 001 does not list the Package.
      
5. In the Package, edit the Scenario step. In the "Properties" "Parameter" at the bottom of the screen, unset "Synchronous / Asynchronous" and select "". Save.
   --> As expected, the "Used by" of Scenario version 001 now lists the Package.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.