My Oracle Support Banner

Tasks Do Not Display Second EDQ Node from the Weblogic Cluster (Doc ID 2710084.1)

Last updated on DECEMBER 06, 2024

Applies to:

Oracle Enterprise Data Quality on Marketplace - Version 2.0 and later
Oracle Enterprise Data Quality - Version 12.2.1.4.0 and later
Information in this document applies to any platform.

Symptoms

After integrating Siebel and Oracle Enterprise Data Quality (EDQ) for contact matching and address verification the tasks do not initiate and display the second EDQ Server Node linked within Weblogic Cluster setup.

Both nodes display within Weblogic as up and running, and Coherence is set-up and displays correctly, but the Cluster/Coherence is NOT seeing or communicating with the Second Node.

The issue was observed when taking the following steps:

1. Create/ install - set up Production with the same set up configuration as the UAT system
2. Start All Servers (Managed Server one and server two)
3. Start EDQ - access scheduled tasks for display
4. When viewing the TASKS section the following was observed 
     There is only Server_1 (Node 1) displayed
     Server_2 (Node 2) is not displayed.

 

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.