RP/TUX 6.4, 6.5, 6.51, 7.1, 8.0 - Change the timeout value used by pclean for partitioning (Doc ID 772788.1)

Last updated on NOVEMBER 04, 2016

Applies to:

Oracle Tuxedo / Tuxedo / 6.4, 6.5, 7.1, 8.0
Information in this document applies to any platform

Goal

DESCRIPTION:
The tmadmin pclean command apparently uses a single SCANUNIT as a timeout value when checking the status of machines
other than the one specified as the argument for the command.  If a relatively small value of SCANUNIT, such as five
seconds, has to be used in a large, busy application, then machines that are actually up can be partitioned as a
result.  They are automatically unpartitioned afterwards but the temporary partitioning caused by the current behavior
of the pclean command can be quite harmful to the application. It is therefore requested that the timeout value be
increased, perhaps to DBBLWAIT * SCANUNIT, which would seem more intuitive than the current behavior.

CONFIGURATION:
Tuxedo 6.4 CTS
Solaris 2.7

Solution

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms