My Oracle Support Banner

How to Turn Off Breaker Load Measurement from SCADA Showing up in Viewer (Doc ID 1053956.1)

Last updated on JANUARY 24, 2019

Applies to:

Oracle Network Management for Utilities - DMS - Version 1.7.1.1 and later
Oracle Utilities Network Management System - Version 1.7.1.1 and later
Information in this document applies to any platform.

Goal

Q1: How can load information from SCADA be turned off so that it does not appear in the Viewer?

Q2: For PFService to read quality values correctly, is ttl=1 required for the status measurement, even for non-status measurements like fault indicators? (might this have changed with the DMS44 referenced in doc 2422051.1?)

Q3: What components are not updated dynamically if ttl=0, e.g of PFService, DDService (momentary processing), measurements displayed on viewer, scada summary

Q4: Does the weblogic switching service require ttl=1 for any reason, e.g. in receiving outcomes of scada operations on digital measurements (non-status points)?

Q5: How much of a performance impact is it if ttl is set to 1 on all measurements?

Q5: If TTL is set to 0 for high volume, non viewer-displayed measurements, does the 'refresh' button on scada summary re-pull all values?


Solution

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Goal
Solution
References

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.