My Oracle Support Banner

In Objectel, Facility Design Incorectly Represented When Adding An Extra-Node Inside The Design (Doc ID 1177023.1)

Last updated on SEPTEMBER 18, 2018

Applies to:

Oracle Communications Objectel - Version: 2.10.1 and later   [Release: 2.10 and later ]
Information in this document applies to any platform.

Symptoms


Facility design incorrectly represented when adding an extra-node inside the design.

Steps you would have followed:
1. Create a Facility between the nodes under same FE.
2. Open the Facility -> next till "Functional Equipment Gap Resolution" window
3. Remove the gap segment
4. Drag& drop new node -> create a gap between source and new node
5. Create a gap between the new nod and the target

The design accumulates 6 nodes making the whole design very confusing. Some of the nodes are duplicated entirely unnecessarily.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
  Symptoms
  Cause
  Solution
  References

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.