In Objectel, Incorrect Network Paths Are Shown In Network during Creation Of Circuits (Doc ID 1221414.1)

Last updated on APRIL 27, 2021

Applies to:

Goal

In Objectel, when you are creating the Circuits, in 'Edit Network Path' path (Sub Circuit Implementation window) window of the circuit, if  'Max Number Of Hops' are set to more than 5 though the all available paths are shown but the details of paths are not shown in lower window.

For example
1)You have created an SONET network with 5 nodes and 6 base facilities by forming ring.
2)When you create a circuit between any of the two nodes,
3)In 'Edit Network Path' path (Sub Circuit Implementation window) of the circuit. 'Max Numbers of Path' and 'Max Number Of Hops' are set to 5.

Notice, the correct paths appear in the upper window, but you’re not able to assign them because they’re not visible in the lower window.

Solution

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.