Cisco Command Neighbor Default-Originate Route-Map Not Appearing In Device Audit Reports (Doc ID 1269897.1)

Last updated on SEPTEMBER 21, 2016

Applies to:

Oracle Communications IP Service Activator - Version: 5.2.4 and later   [Release: 5.2 and later ]
Information in this document applies to any platform.

Symptoms

The command below was pushed to the device but the device audit would not display the command:

neighbor <ip address> default-originate route-map <name>

Changes

Upgrade to IPSA5.2.4 Patch 12

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms