My Oracle Support Banner

Martini Qinq Juniper Error - Interface does not have a VLAN ID specified (Doc ID 1299811.1)

Last updated on MAY 29, 2018

Applies to:

Oracle Communications IP Service Activator - Version: 5.2.4 and later   [Release: 5.2 and later ]
Information in this document applies to any platform.


In the martini end point (ethernetVlan) subinterface if QinQ tagging is used (inner and outer VLAN), the outer VLAN is discovered in IPSA as expected but the configuration is getting rejected with the following message:

"Device configation could not be applied - transaction rejected (Interface ge-1/1/1 unit 800 does not have a VLAN ID specified and conflicts with current configuration)"

Subinterface is:
unit 800 {
description "SRT Martini Site2";
encapsulation vlan-ccc;
vlan-tags outer 800 inner 50;
input-vlan-map pop;
output-vlan-map swap-push;
family ccc {
policer {
input 2M;
output 2M;

VLAN 800 is discovered in IPSA properly. But it is not allowing this configuration to be pushed.


To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.