My Oracle Support Banner

Validation Procedure Fired Multivates Are Missing From Discrepancy Database (Doc ID 1319464.1)

Last updated on FEBRUARY 19, 2019

Applies to:

Oracle Clinical - Version 4.6.0 and later
Information in this document applies to any platform.


On : 4.6.0 version, Procedures, Discrepancy, DCF's, Mass Changes, Batch Data Load, In & Out of Study

 You have encountered a strange behavior where in  the Procedure execution log shows  4 discrepancies are created but when you look at the discrepancy table, only 2 are getting created.

This is happening when the Procedure had two question group in the validation procedure with one repeating question group.  It look like somehow only the 1st repeat is getting save in the table.
This is only happening in TEST mode.

Expected the system to generate the number of discrepancies in the Discrepancy table as listed in the Procedure validation log file.

The issue can be reproduced at will with the following steps:
1. Define Validation procedure
2. Execute Validation procedure in Test mode
3. Test log shows it has created 4 discrepancies
4. Check discrepancy_entries  table and there are only 2 discrepancies listed




To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.