Error While Selecting 'Mark If Not Done' Checkbox In Rdc Mode (Doc ID 1346833.1)

Last updated on FEBRUARY 11, 2019

Applies to:

Symptoms

=== ODM Issue Clarification ===

On : 4.6.0 version, HTML Data Entry

When attempting to Mark the CRF as Blank using a Layout generated where Show Blank is selected at the DCI Module Level,
the following error occurs.

ERROR
-----------------------
"Can't move focus to the control because it is invisible, not enabled, or of a type that does not accept the focus. "


STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1) Created FLT with the following (LANDSCAPE):
    NP_LANDSCAPE
    Template Width = 684
    Template Height = 540
    Header Height = 60
    Footer Height = 45
    DCM Region Height = 435

 Footer was created with non-enterable fields

2) Created a DCM = DEMOG, VITALS
    Generated the DCM with the new FLT created.
 
3) Created DCI = SAMPLE_SINGL (using DCM = DEMOG), SAMPLE_MULTI (using DCM =
 DEMOG, VITALS) , make sure to select Show Blank
 Uncheck the DCI date, change the Visit Display = NAME ONLY
 Generate DCI Provisional Layout, Generate Provisional Form

4) Save and include in the Enhanced DCI Book

5) Login to RDC Onsite

6) Open CRF and click Intentionally Blank , and I get the following error:
     "Can't move focus to the control because it is invisible, not enabled, or of
       a type that does not accept the focus. "

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.