UIM: Restrict Termination Of Specific Device Interfaces To Pipe Termination Points. (Doc ID 1349123.1)

Last updated on SEPTEMBER 02, 2016

Applies to:

Oracle Communications Unified Inventory Management - Version 7.1.2 and later
Information in this document applies to any platform.

Symptoms

Currently when clicking on the 'Add - Device Interface Termination' link on Summary page of Pipe TP gives the list of all DI in the Data Base if no criteria is used.
New functionality has been requested which expects UIM to display the list of only those DIs which are associated to the LDs connected by the corresponding Pipe.


Example:
Consider a network with two nodes
1)- Logical Devices associated to each node (LD's associated have Device Interface also)
2)- Both the nodes are connected through an edge associated to a Pipe.
3)- From here go to pipe summary page and then to it's termination point summary page.
4)- Now we want to terminate DI to this Pipe TP, it should show only those DI's which belong to LD's associated to the nodes between which the edge is created rather than showing all the DI's .

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms