My Oracle Support Banner

Juniper base catridge does not handle MX prompt (Doc ID 1373324.1)

Last updated on MAY 29, 2018

Applies to:

Oracle Communications IP Service Activator - Version: 5.2.4 and later   [Release: 5.2 and later ]
Information in this document applies to any platform.


The customer was experiencing an issue with a juniper MX device where the prompt is not getting matched by the prepend pattern in the juniper base catridge

The customer had the following error in the logs

20110922-092349|366|trace2|Thread-14||||proxy_np|pundipsaapd|t-read-prompt:set vlans VLAN_TEST778 vlan-id 778 __{master:0}[edit]_admin@LABSWITCH1# :e-t-read-prompt
20110922-092349|366|trace2|Thread-14||||proxy_np|pundipsaapd|matched-prompt:(? s)\n+(?:\{(master|backup)\}[ ]+)?(?:\[edit\]\n)?admin@LABSWITCH1[>#][ ]:e-matched-prompt
20110922-092349|366|trace2|Thread-14||||proxy_np|pundipsaapd|||  ->{master:0}[edit]
20110922-092349|367|trace1|Thread-14||||proxy_np|pundipsaapd|Disconnect telnet session for /
20110922-092349|379|FATAL|Thread-14||||proxy_np|pundipsaapd|Caught CommandExecutorException com.metasolv.serviceactivator.networkprocessor.CommandExecutorException: command: set vlans VLAN_TEST778 vlan-id 778 / response: {master:0 [edit] /


To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.