Is It Possible To See Same Information With Different UOMs In APCC?
Last updated on FEBRUARY 15, 2018
Applies to:
Oracle Advanced Planning Command Center - Version 12.1.3 and laterInformation in this document applies to any platform.
Goal
Is it possible to see same information with different unit of measure (UOM) codes in APCC?
Trying to see some facts but using different Units Of Measure (UOM). In ASCP, one can use only one UOM to run the plans, but may upload the corresponding information to the table MSC_UOM_CONVERSIONS, with conversions between them.
In APCC, can see these codes when selecting the "UOM code", but once adding a fact, can only see the UOM that was used in ASCP.
The question is:
Is it possible to see also the fact in others' UOM different than the one used in ASCP? Need to advise.
Solution
Sign In with your My Oracle Support account |
|
Don't have a My Oracle Support account? Click to get started |
My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms