DM DATA MODEL After Building The Model The Proport Procedure May Not Be Called During Data Loading. (Doc ID 1510428.1)

Last updated on SEPTEMBER 08, 2016

Applies to:

Oracle Demantra Demand Management - Version 7.3.1.4 and later
Information in this document applies to any platform.

Symptoms

 It happened in demantra 7.3.1.4.

I build a new model in BM and set the system parameters RunProportInMdp_add = 1 and Run_full_matrix_proport = 0.
After loading using load_data.bat, all prediction_status values of MDP_MATRIX is 98.
I checked the procedure mdp_add which called proport procedure like previous version(7.3.1.3).

There is a comment about proport " For MDP_ADD run with MDP_LOAD_ASSIST then PROPORT is run from EP_LOAD_MDP_LEVEL ".
However, in ep_load_mdp_level procedure, the source code is only "dynamic_ddl('TRUNCATE TABLE MDP_LOAD_ASSIST');" like the previous version of demantra.
but, if I install demantra 7.3.1.4 with standard demo then the procedure has a source code for proport.

I'm wondering if demantra 7.3.1.4 support building model or not.
In previous version of demantra does not have any problem with same model and data.

Changes

 upgrade Demantra 7313 - 7314

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms