New Manual IMD BO Is Not Recognized As Override BO Option During Measurement Re-evaluation. (Doc ID 1530598.1)

Last updated on FEBRUARY 20, 2013

Applies to:

Oracle Utilities Service and Measurement Data Foundation - Version 2.0.1 and later
Information in this document applies to any platform.

Symptoms

Attempting to use anything other than BO D1-ManualIMDScalar as the 'Manual Override IMD BO' during measurement re-evaluation is ignored.  This includes both of the following situations:

  1. A base measuring component BO (e.g. D1-Register), with two 'Manual Override IMD BO' options defined - Seq 10 as D1-ManualIMDScalar, Seq 20 as a CM BO.  In this situation, only D1-ManualIMDScalar is used, whereas a configuration such as this should result in the CM BO being used.
  2. A CM measuring component BO defines a single 'Manual Override IMD BO' which is also CM BO.  In this situation, re-evaluation does not result in any new (manual) measurements being created. 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms