pin_mta_get_int_from_pinconf Does Not Set Value in Application Flist If Pin.conf Value Set 0 (Doc ID 1910637.1)

Last updated on AUGUST 04, 2014

Applies to:

Oracle Communications Billing and Revenue Management - Version 7.3.1.0.0 to 7.3.1.0.0 [Release 7.3.1]
Information in this document applies to any platform.

Symptoms

On : BRM 7.3.1.0.0 version, MTA

pin_mta_get_int_from_pinconf is not setting the value to application flist if the value is 0 in pin.conf. while it does when it is 1.

EXPECTED BEHAVIOR
-----------------------
The value should be present in the application flist.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Add one dummy pin.conf parameter whose value should be 0
2. In the MTA code use pin_mta_get_int_from_pinconf function to get the dummy pin.conf parameter in the application flist.
3. Result shown that application flist does not has dummy parameter.

 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms