Validation error: Expected elements 'maxRoutes defaultMdt dataMdt dataMdtReuse' instead of 'routeLimitIPv6' here in element vrf (Doc ID 1951500.1)

Last updated on AUGUST 14, 2017

Applies to:

Oracle Communications IP Service Activator - Version 7.2.0 and later
Information in this document applies to any platform.

Symptoms

On performing an upgrade of IPSA from 7.2.0.5 to 7.2.0.7, we had problems with the managed devices and the service model after we started up the network processors on the patch 7 release.

They all have 'routeLimitIPv6' in common, and on the sample PEs I checked, we have no IPv6 configuration on the devices. The elements IPSA was expecting is 'exportMap, maxRoutes, defaultMdt, dataMdt, dataMdtReuse etc.'. This is with error 100.1221.

They were paired with a 100.3300 error saying 'Target device model for is not valid'.

Error Message NetworkProcessor log:

20141113-054844|978|DEBUG|Thread-8||||proxy_np|smcevoy-lnx-au|validateDm:Validation error: Expected elements 'maxRoutes defaultMdt dataMdt dataMdtReuse' instead of 'routeLimitIPv6' here in element vrf
20141113-054844|979|ERROR|Thread-8|212.74.66.110|||proxy_np|smcevoy-lnx-au|Caught XML exception org.apache.xmlbeans.XmlException: Target device model for device router1 is not valid

 

This issue only affects cisco devices managed by the Cisco IOS Cartridge.

Step's to reproduce:
- Create a VRF
- with both exportMap and routeLimit defined

This has been tested with just IPv4 and also with IPv6.

 

 

Changes

 Upgrade to IPSA 7.2.0 Patch 7

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms