User Need Option To Specify Start & End Range While Building Virtual Ports In Equipment Inventory (Doc ID 1999884.1)

Last updated on MAY 04, 2015

Applies to:

Oracle Communications MetaSolv Solution - Version 6.2.1 and later
Information in this document applies to any platform.

Symptoms

User  wants an option(in MSS 6.2.1 ) in the window "Build Virtual Ports" to give Node Address number From and To , so that the virtual ports may be built only for those ports randomly as per the need.

This is required in the following scenarios:

1)Suppose, if the user's requirement is to build only 4 virtual ports with addresses N3, N4, N5 and N6 out of 20. ,then a possible work-around is to rename the already created ones. But if there is an option where the user can put a range of ports to be created like for this Start  Range =3 and End Range=6 , then its much easier and efficient .

2)Secondly , absence of this functionality is also causing unnecessary creation of multiple virtual ports when the requirement is to build only few virtual ports out of the total. For example :sometimes user needs specific Node Address (say N7 referring to this example).Now going by the current functionality , it can be done either by the work-around of renaming ports or creating ports sequentially from N1 to N7 only to use N7 with ports N1 to N6 not required.

 

 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms