My Oracle Support Banner

Flow Manufacturing In APCC (Doc ID 2012991.1)

Last updated on FEBRUARY 03, 2019

Applies to:

Oracle Advanced Planning Command Center - Version 12.2.4 and later
Information in this document applies to any platform.

Symptoms

On : 12.2.4 version, Reports and Dashboards

ACTUAL BEHAVIOR
---------------
Customer is trying to create a report for Flow Manufacturing based on the Advanced Planning Facts and Dimensions. He is going to the Supply Chain Analyst dashboard, and is selecting "New -> Analysis".
He wants to include the following facts / dimensions:

1. Line
2. Available rate
3. Required rate
4. Net available rate
5. Capacity Load Ratio
6. Net ATP

According to Development:

Calculate line, Net avail rate, Capacity Load Ratio, net ATP are not available in APCC as dimensions and facts.

The fact / dimension that represents a line is Resource, and the only things he can add to the report are "Required Hours, Available Hours" and for flow mfg that will display the information for "Available rate and Required rate".

However, when the customer tries to create a report with only these facts / dimensions, they don't see any line item data.

EXPECTED BEHAVIOR
-----------------------
Expect to see the line item data in the report

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Add facts / dimensions to the report as mentioned above
2. Note that no data is shown

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


This document is being delivered to you via Oracle Support's Rapid Visibility (RaV) process and therefore has not been subject to an independent technical review.
My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.