After Executing CMT/pin.conf File Has a Bad Log Path

(Doc ID 2013905.1)

Last updated on JULY 28, 2017

Applies to:

Oracle Communications Billing and Revenue Management - Version to [Release 7.5.0]
Information in this document applies to any platform.


On : version, Upgrade


After installing patchset 9, the script was executed. On doing this action, the pin conf file in CMT folder got updated with an incorrect path for mta log file.

Actual behavior:

Below is the path updated in the CMTs pin conf file :

             - pin_mta logfile ${PIN_LOG_DIR}/

Expected behavior:

The correct path should be :

             - pin_mta logfile ${PIN_LOG_DIR}/cmt/cmt_mta.pinlog

Steps to reproduce:

1. In fresh environment, installed 7.5 PS6
2  Install the ./7.5PS9_ThirdParty_linux_32_opt.bin and source /opt/portal/7.5/ThirdPartyApps/
3. Make sure the perl link of PIN_HOME/bin/perl is pointing to latest perl version [ 5.18.2].
4. Install ./7.5PS9_19133869_Portal_Base_linux_32_opt.bin and source /opt/portal/7.5/
5. Install ./7.5PS9_PortalBase_Upgrade_75_75PS_linux_32_opt.bin
6. Took the backup of pin.conf [from CMT folder].
7. Run (This gave error about not found. So corrected the PERL5LIB and executed the pl file again).
8. Installation went fine .
9. Check cmt/pin.conf file, it has wrong path for the log file.


Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms