My Oracle Support Banner

Material Plan Projected Available Balance PAB Is Not Correct In Weekly View (Doc ID 2014452.1)

Last updated on AUGUST 19, 2019

Applies to:

Oracle Rapid Planning - Version 12.2.4 and later
Information in this document applies to any platform.


On : 12.2.4 version, Planning Engine

[RP]Material Plan:PAB is not correct in weekly view

When customer sees demand/supply/projected available balance(PAB) at Day axis, 7-days PAB looks like this;

Gross requirements: 0,15000,15000,15000,15000,0,30000
Total supply: 0,15000,15000,15000,15000,15000,15000
PAB: 0,0,0,0,0,15000,0

Then, when customer changes axis to Week, demand, supply and PAB are shown as follows.  How is the PAB calculated? The PAB should be zero(=Total supply-Gross requirement)

                                                      5/11/2015                       5/18/2015                      5/19/2015
Forecast                                                0                                         0                              0
Manual Demand                                    0                                         0                              0
Dependent demand                            90,000                          15,000                              0
Gross requirements                            90,000                          15,000                              0
Beginning on hand                                0                                         0                              0
Work orders                                        90,000                          15,000                             0
Planned orders                                      0                                         0                              0
Total supply                                        90,000                          15,000                              0
Projected available balance                15,000                                  0                              0

The issue occurred for the item:280010901#LPA055A093C in the plan starting from May 11, but in another plan starting from May 12, the item's PAB at Week axis is correct.

The issue can be reproduced at will with the following steps:
1. Navigate to Responsibility > Supply Chain Simulation Planner.
2. See the Material Plan for a plan and item
3. observe the above.


To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.