Default Referral Code Should Be Blank
(Doc ID 2039200.1)
Last updated on DECEMBER 03, 2019
Applies to:
Oracle Utilities Network Management System - Version 1.11.0.4 and laterOracle Network Management for Utilities - DMS - Version 1.11.0.4 and later
Information in this document applies to any platform.
Goal
What is required to change the default referral code from the current SRV (defined in product) to something else? Ideally a blank would be wanted.
When changing it to a blank, it causes an error: "Key data source is not valid for CMB_REFER_TO"
The product configuration defines the following valid RAPID_REFERRAL table entries that are used:
Solution
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
Goal |
Solution |