My Oracle Support Banner

'Device Already In Desired State' Error When Operating a SCADA Control in Web Switching (Doc ID 2045954.1)

Last updated on FEBRUARY 03, 2019

Applies to:

Oracle Utilities Network Management System - Version 1.12.0.1 and later
Oracle Network Management for Utilities - DMS - Version 1.12.0.1 and later
Information in this document applies to any platform.

Symptoms

On : 1.12.0.1 version, Web Switching

SCADA controls from web switching indicate they are already in the actual state when they are not

When executing SCADA controls from Web switching, an error dialog pops up to say "Device is already in the desired state" when this is not the case. ( for example, a suppress command on an auto-recloser which is 'enabled' will pop this dialog. Whereas a 'restore' command on an 'enabled' device doesn't indicate that it is in the desired state.


ERROR
-----------------------

"The device is already in the desired state."



STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Attempt to complete a device operation step on a SCADA control

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.