Instructing A Non-SCADA Tag On A SCADA Device Goes To Status SCADA Pending Instead Of Instructed (Doc ID 2154187.1)

Last updated on JULY 05, 2016

Applies to:

Oracle Utilities Network Management System - Version 1.12.0.3 to 1.12.0.3 [Release 1.12]
Oracle Network Management for Utilities - DMS - Version 1.12.0.3 to 1.12.0.3 [Release 1.12]
Information in this document applies to any platform.

Symptoms

Instructing a non-SCADA tag on a SCADA device goes to status "SCADA Pending" instead of "Instructed"

When a non-SCADA tag is recorded and placed on a SCADA device, then the step is instructed in switching, the step moves to a status of "SCADA Pending" in switching instead of "Instructed".


The step should be going to an "Instructed" state rather than "SCADA Pending".


Steps:
1. Navigate to a SCADA device
2. Create a new switch plan and record the step of placing a non-SCADA tag or note.  This is evaluated by checking that the tag or note condition is not configured in the SCADA_CONTROLS table for the selected device.
3. Switch to real time and instruct the tagging step and notice in the switch plan the step moves to a status of SCADA Pending instead of Instructed

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms