Digital Measurement Flag Does not Clear From the Viewer When Values Changes Back to the Default (Doc ID 2186880.1)

Last updated on SEPTEMBER 26, 2016

Applies to:

Oracle Network Management for Utilities - DMS - Version 1.12.0.3 to 1.12.0.3 [Release 1.12]
Oracle Utilities Network Management System - Version 1.12.0.3 to 1.12.0.3 [Release 1.12]
Information in this document applies to any platform.

Symptoms

On : 1.12.0.3 version, Web Workspace

The customer has a condition_rule defined for a specific digital measurement so a flag will get shown in the viewer when the value is set to 0.

The Digital Measurement flag does not get cleared in the Viewer when values changes to back to the default (which has no entry in the condition_rules table).


The expected behavior is:
When the value for the attribute is set to its non-default value, the defined condition symbol appears in the viewer
When the value for the attribute is set back to its default value, the condition flag disappears from the viewer




The issue can be reproduced at will with the following steps:
1. Change the value of digital measurement attribute to a non-"off" value.
2. Change the value of the attribute its off value.
3. The original non-"off" symbol does not get cleared out.


Changes

 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms