Creo MCAD connector cannot map automatic Creo parameters from the Mapping Editor to Agile (Doc ID 2192489.1)

Last updated on OCTOBER 12, 2016

Applies to:

Oracle Agile PLM MCAD Connector - Version 3.0.0 and later
Information in this document applies to any platform.

Symptoms

Using Creo MCAD connector version 3.4 with Creo 3 and Agile PLM 9.3.4. The user has some issues when trying to map to Agile an automatic Creo parameter via Mapping Editor. If he uses the Mapping Editor to map user defined parameters to Agile everything goes fine but if he inserts in the mapping editor an automatic Creo parameter ( not created by the user)  the mapping doesn't work and the corresponding value does not appear in Agile.

The automatic Creo parameters we would like to map are: total_sheets, scale.
Expected Behavior:
An automatic creo parameter should be easily mapped to Agile


Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms