Control Tool Does not Indicate on Which Port a Ground Condition Resides (Doc ID 2194008.1)

Last updated on OCTOBER 17, 2016

Applies to:

Oracle Utilities Network Management System - Version 1.12.0.3 and later
Oracle Network Management for Utilities - DMS - Version 1.12.0.3 and later
Information in this document applies to any platform.

Symptoms

On : 1.12.0.3 version, Web Workspace

The Control Tool currently does not provide a flag that tells you which side has a ground (upstream/downstream). The Control Tool should be enhanced to provide some mechanism/flags which would allow the control of the sensitivity of these buttons based on if an upstream or downstream earth was available (e.g. HAS_UPSTREAM_GROUND, HAS_DOWNSTREAM_GROUND....in addition to the usual HAS_GROUND). This would then allow a project to control the button sensitivity properly on the various multiple versions of the apply/remove earth options that may be on a device.

2) The Remove Upstream Ground option on a switch should only remove an earth if one exists on the upstream side. If more than one exists on the upstream side, then a pop up dialog should be provided. Likewise, same relevant logic should be applied to the Remove Downstream Ground option. Currently this is not the case and the RemoveGroundCommand does not appear to honour only removing the ground on the configured side.


Changes

 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms