My Oracle Support Banner

INCFIF - Generate Forecast Concurrent Request Does Not Create Correct Forecast Quantity By Customer (Doc ID 2208124.1)

Last updated on OCTOBER 03, 2018

Applies to:

Oracle Materials Requirement Planning - Version 12.1.3 and later
Information in this document applies to any platform.

Symptoms

On : 12.1.3 version, Forecast in Test:

Users are using the Oracle Material Requirements Planning module. In the MRP module users have defined a Forecast Set = Premier with Forecast = FOCUS. They added a Customer called CHEF MIDDLE EAST - They then ran Generate Forecast concurrent request and then check the forecast. They see qty = 7100 for all forecast buckets. They remove Customer called CHEF MIDDLE EAST and rerun the Generate Forecast request and again all the qty = 7100 for all forecast buckets.

EXPECTED BEHAVIOR
-----------------------
Expect to see forecast created based on demand history for Customer called CHEF MIDDLE EAST when generating the forecast

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Setup Forecast Rule
2. Setup Forecast and Forecast set with and without customer
3. Make sure all data has been pushed to table mtl_demand_histories
4. Run Generate Forecast concurrent request with and without customer setup in the Forecast
5. Forecast output is the same whether you specify a customer or not

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution


This document is being delivered to you via Oracle Support's Rapid Visibility (RaV) process and therefore has not been subject to an independent technical review.
My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.