My Oracle Support Banner

BOM parts are Cannot be Saved/Published into Agile PLM from SolidWorks Using The MCAD Connector (Doc ID 2220531.1)

Last updated on AUGUST 11, 2022

Applies to:

Oracle Agile PLM MCAD Connector - Version 3.3.0 and later
Information in this document applies to any platform.

Symptoms

On MCAD 3.5.0 for SolidWorks with Agile PLM 9.3.5

BOM parts are not being transferred from SolidWorks to Agile PLM. The BOM tab in Agile PLM is empty
not able to execute BOM creation from Solidworks as explained in MCAD user guide, I am not bale to find BOM Publish command, I am not able to find any admin configurations for this, Please share me user manual or help me how to generate BOM from Soliwdworks.

Expected Behavior

The BOM parts should be transferred from SolidWorks to Agile PLM.

Steps To Reproduce:


The issue can be reproduced at will with the following steps:
1. Save /check in an Assembly from SolidWorks to Agile using the MCAD connector
2. In Agile verify the assembly part and see that there in no parts under the BOM tab.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document
Symptoms
Cause
Solution


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.