Rapid Planning Simulation Gets Stuck With Log Message -

(Doc ID 2233547.1)

Last updated on JUNE 29, 2017

Applies to:

Oracle Rapid Planning - Version and later
Information in this document applies to any platform.

 FMW TechStack applied
engine.zip 120.46.12010000.271

After upgrade - testing cycle
Executed following steps:
* Copied an ASCP plan to RP plan with 180 days horizon
* create a manual hot demand and save
* Launch the plan

We thought plan was stuck after 1 hours - but then noticed that plan got completed.
It took more than 2 hours to simulate after a hot demand was added.
For this plan, horizon was 180 days.

We did tried same thing for smaller horizon and sometime process is stuck for few hours and sometime gets completed. But there is no consistency.

 rpengine7024.log. - is for plan_id = 17023

file RP-06.log
#### <[ACTIVE] ExecuteThread: '1' for queue: 'weblogic.kernel.Default (self-tuning)'> <> <> <> <[STUCK] ExecuteThread: '0' for queue: 'weblogic.kernel.Default (self-tuning)' has been busy for "1,820" seconds working on the request "Workmanager: default, Version: 1, Scheduled=false, Started=true, Started time: 1820439 ms
", which is more than the configured time (StuckThreadMaxTime) of "1,800" seconds. Stack trace:
Thread-15 "[STUCK] ExecuteThread: '0' for queue: 'weblogic.kernel.Default (self-tuning)'" <alive, suspended, priority=1, DAEMON> {

plan will run quickly and finish as consistently.

cannot validate RP after this upgrade


Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms