My Oracle Support Banner

Grounds are Appearing on the Wrong Side of the Grounded Device (Doc ID 2234196.1)

Last updated on FEBRUARY 03, 2019

Applies to:

Oracle Network Management for Utilities - DMS - Version 1.12.0.3 to 1.12.0.3 [Release 1.12]
Oracle Network Management for Utilities - DMS - Version 2.3.0.0.0 to 2.3.0.0.0 [Release 2.3]
Oracle Utilities Network Management System - Version 1.12.0.3 to 1.12.0.3 [Release 1.12]
Oracle Utilities Network Management System - Version 2.3.0.0.0 to 2.3.0.0.0 [Release 2.3]
Information in this document applies to any platform.

Symptoms

Grounds are appearing on the wrong side of the grounded device.

The issue can be reproduced with the following steps:

On a system where conductors are modeled such that when a switch is connected to two conductors, the diagrams for the two conductors appear to touch directly under the center of the switch diagram.
1. Place a ground on the upstream port of a switch where the diagrams for the conductors touch the middle of the switch's diagram.
2. Observe where the ground gets drawn.
3. Remove the ground.
4. Place a ground on the downstream port of the same switch.
5. Observe that the ground gets placed in the same location.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.