NCG Intermittently Not Getting Filled when Adding Devices to Safety Document Tag Points Table (Doc ID 2239939.1)

Last updated on MARCH 06, 2017

Applies to:

Oracle Utilities Network Management System - Version 1.12.0.3 to 2.3.0.0.0 [Release 1.12 to 2.3]
Oracle Network Management for Utilities - DMS - Version 1.12.0.3 to 2.3.0.0.0 [Release 1.12 to 2.3]
Information in this document applies to any platform.

Symptoms

NCG intermittently is not getting filled when adding devices to safety document tag points table.

I can select a master device or record a step for a device and I’ll get the correct ncg.  But when I record that device into the tag points table of a safety document I don’t get the correct ncg. I get the fuzzy ncg.

It is expected that the NCG would be consistent when recording a device into a safety doc.

The issue can be reproduced with the following steps:
1. Create a safety doc and add a master device
2. Add the same device into the tag points for the safety doc
3. Review SWMAN_STEP entries for the device

Changes

 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms