My Oracle Support Banner

LOOPBACK Config Not Working Properly After ASAP Upgraded To 7.2.0.6.* or 7.3.0 (Doc ID 2251962.1)

Last updated on FEBRUARY 20, 2019

Applies to:

Oracle Communications ASAP - Version 7.2.0 to 7.3.0.0.0 [Release 7.2 to 7.3.0]
Information in this document applies to any platform.

Symptoms

The LOOPBACK config not working properly after an ASAP upgrade from version 7.2.0.0 to 7.2.0.6.* or 7.3.0.0 or 7.3.0.1.

Post upgrade, an issue is found in LOOPBACK manipulation in system as follows:

Loopback manipulation per NEP/NE does not work. Able to set whole system in live/loopback, but not a single NEP. The NEP is always picking the mode of a system setting, ignoring the setting within its own [NEP] section. For example if the system is set to livemode (LOOPBACK_ON=0), but in [NEPxxx] section, LOOPBACK_ON=1. During ASDL processing it says "Provisioning in Live mode".

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.