Phase Information not Shown for Condition (Doc ID 2254033.1)

Last updated on APRIL 11, 2017

Applies to:

Oracle Utilities Network Management System - Version 1.11.0 and later
Oracle Network Management for Utilities - DMS - Version 1.11.0 and later
Information in this document applies to any platform.

Symptoms

After placing a new condition ( "cut_bell" ) on phase A of a three-phase device, the "Phase" column is blank in the Condition Summary and in the Remove Condition dialog.
Also, the Viewer is not showing any phase lettering for the new condition.

If you place a Note or Wire Down on phases A and C, the letters "AC" appear in the Phase column and in the Viewer.


Changes

A new condition class cut_bell was added to the model.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms