My Oracle Support Banner

Save Preview Window Takes Too Long to Open When a Family Table Part is Used in an Assembly (Doc ID 2281524.1)

Last updated on FEBRUARY 24, 2019

Applies to:

Oracle Agile PLM MCAD Connector - Version 3.5.0 and later
Information in this document applies to any platform.

Symptoms

When using MCAD, the save preview window takes too long to open when a family table part is used in an assembly. This issue can occur when using a large number of part family instances in Creo (e.g.: more than 10).

Steps to reproduce:

  1. Try to bring up the save preview window on an assembly using a large number of part family instances in Creo.
  2. Notice it takes a long time to open.

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.