FLISR (Auto Mode) Gives Wrong Message for Manual Demotion Cause

(Doc ID 2287855.1)

Last updated on JULY 25, 2017

Applies to:

Oracle Network Management for Utilities - DMS - Version 1.12.0.3 to 2.3.0.0.0 [Release 1.12 to 2.3]
Oracle Utilities Network Management System - Version 1.12.0.3 to 2.3.0.0.0 [Release 1.12 to 2.3]
Information in this document applies to any platform.

Symptoms

When running FLISR in Auto mode, if a solution is demoted because a feeder is not in the correct state, the error message says the feeder is in manual mode, when it is not.

'3110: Event demoted for manual execution. Restoration Feeder [$VAL1] is in manual mode'


The issue can be reproduced with these steps:

1. Make sure that SRS rule 'FLISR Disable Feeder for Restoration Time' is set to 600 and FLISR is set to run in auto mode.
2. Create a FLISR event on a test feeder which has only one possible restoration feeder
3. Reset the test feeder
4. Again create a FLISR event on the same test feeder
5. Open the FLISR report and observe the message '3110: Event demoted for manual execution. Restoration Feeder [$VAL1] is in manual mode'

Changes

 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms